How to remove a switch from a stack (Cisco)

Subscribe to my newsletter and never miss my upcoming articles

Last week I had to "Break" a stack where there were four switches and I needed to use one outside in an IDF.

Executing the show run command showed there were indeed 4 switches in the stack-

switch 1 provision ws-c3750x-48p
switch 2 provision ws-c3750x-48p
switch 3 provision ws-c3750x-48p
switch 4 provision ws-c3750x-48p

In order to remove switch 4 I had to run the following command (In configuration mode)-

no switch 4 provision ws-c3750x-48p

wr mem

After that- Power down the stack, remove the necessary cables, and re-cable the stack. Upon rebooting the switches you should no longer see the switch which has been removed.

No Comments Yet